CSC102Lab4F2021 < CenterForComputing

<b><u>Lab 4 – Tuesday, September 14, 2021</u></b>

Topic: Loops, Selection, and Parallel Programming

Description: This lab session will focus on getting your vehicle to drive itself around a “track” and make adjustments based on sensor feedback.

Details:
   1 The “track” is a path drawn on the large roll of paper taped to the floor in the professor’s office. You need to move counterclockwise around the track.
Components:
   1 Go to *Units* and select *Robot Trainer*. Complete the <b>Colors and Lines </b>tutorial.
   1 Use the color sensor you added during the tutorial to guide the vehicle along the path. If the sensor goes off the path, the vehicle should turn until it finds the path again and then continue along the path (similar to the tutorial).
   1 Your vehicle should stop if the center brick button is pressed.
Extra Credit:
   1 Add a touch sensor to stop if the vehicle runs into something.
   1 Minimize the amount of zig-zag’ing as much as possible to ensure a smooth trajectory around the track.

This topic: CenterForComputing > WebHome > SyllabiFall2021 > CSC102SylF2021 > CSC102Lab4F2021
Topic revision: r1 - 2021-08-24 - craiggoehler